SONY IFB-40
Manual de Servicio

1-2 (E) IFB-40
8

English

The IFB-40 signal interface board is a PC board to be mounted on the PC-3000 to connect a switcher�s REMOTE 1 connector to that of a projector using a SIC-M cable or CCQ cable.

WARNING
For the customers in the USA This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: � Reorient or relocate the receiving antenna. � Increase the separation between the equipment and receiver. � Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. � Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. For the customers in Canada This Class A digital apparatus complies with Canadian ICES-003.

Location and Function of Parts

1
REMOTE 1

2

3
MODE

IN

OUT

1 Indicator (Red) When the IFB-40 is mounted on a projector Lights up when it is selected. When the IFB-40 is mounted on a switcher Lights up usually when a switcher functions. 2 REMOTE 1 IN/OUT connector (14-pin multi connector) IN connector: Connect to the switcher�s REMOTE 1 connector when the PC board is mounted on a projector. When connecting two projectors, connect to the REMOTE 1 OUT connector of the IFB-40 mounted on another projector. OUT connector: Connect to the REMOTE 1 IN connector of the IFB-40 mounted on a projector or a switcher. 3 MODE selector Turn the control switch of the MODE selector to the appropriate position according to the length of the cable connecting the OUT of the REMOTE 1 connector. Cable length Type of cable up to 2 m
SIC-M-1 CCQ-2BRS

up to 10 m

up to 25 m

up to 50 m

SIC-M-5 SIC-M-15 SIC-M-50 CCQ-5BRS CCQ-25BRS CCQ-50BRS CCQ-10BRS SIC-M-25

Position

1

2

3

4

9