ONKYO HTR320
Manual de Usuario

Advanced Setup�Continued

7
ENTER

ENTER

Use the Down [ ] button to select �Surr Back,� and use the Left and Right [ ]/[ ] buttons to select Small, Large, or None. Small: Select if the surround back speaker is small. Large: Select if the surround back speaker is large. None: Select if no surround back speaker is connected. Notes: � If the Surround setting in step 6 is set to None, this setting does not appear. � If the Surround setting in step 6 is set to Small, the Large option cannot be selected.

9

Press the [SETUP] button. Setup closes.

Notes: � For a more accurate setting, look up the frequency response in the manuals supplied with your speakers and set accordingly. In addition, listen to some music that you know well and choose a higher crossover frequency if you think there�s not enough sound coming from the subwoofer; a lower setting if you think there�s too much.

To test that all of your speakers are working properly, press the remote controller�s [TEST TONE] button. The test tone will be output by each speaker in turn and the name of each speaker will appear on the display. To turn off the test tone, press the [TEST TONE] button again. � If the test tone is not produced by a speaker, or it�s produced by a speaker other than that shown on the display, you may have wired your speakers incorrectly and you should check your connections (see page 17). � If the test tone is not produced by a speaker and its name does not appear on the display, you may have set the speaker settings incorrectly (see page 48).

Crossover Frequency
To get the best bass performance from your speaker system, you need to set the crossover frequency according to the size and frequency response of your subwoofer and other speakers (front, center, and surround).

8
ENTER

ENTER

Use the Down [ ] button to select �Crossover,� and then use the Left and Right [ ]/[ ] buttons to select a crossover frequency. Choose a crossover frequency suitable for your setup. If you�re using a subwoofer, choose a crossover frequency based on the diameter of your front speakers. If you�re not using a subwoofer, use the diameter of the �rst speaker that you speci�ed as Small in steps 4 through 7 in the �Speaker con�guration� setting.
Speaker cone diameter Over 8 in. (20 cm) 6-1/2 to 8 in. (16�20 cm) 5-1/4 to 6-1/2 in. (13�16 cm) 3-1/2 to 5-1/4 in. (9�13 cm) Under 3-1/2 in. (9 cm) Crossover frequency 60Hz 80Hz 100Hz (default) 120Hz 150Hz