No hay comentarios de productos.
3.2.4 Removing the loading motor (See Figure 3-2k and Figure 3-2l) � Prior to the following procedure, remove the tray, the traverse mechanism assembly, and the elevator. (1) Remove the belt from the pulley. (2) Remove two screws C attaching the loading motor. (3) Remove two solders h on the switch board.
Belt Pulley C
Loading base Slide cam
Pulley C
Fig.3-2k
Switch board Part h
Loading motor
Fig.3-2l 3.3 Traverse mechanism assembly
3.3.1 Removing the pickup (See Figure 3-3a, Figure 3-3b) � Prior to the following procedure, remove the traverse mechanism assembly. (1) Remove one screw D attaching the plate. (2) Remove the plate and the leaf spring. (3) Lift i of the shaft 1, and pull out the shaft 1 from j. (4) Remove k of the pickup from the shaft 2. Attaching the pickup: (1) Engage k of the pickup to the shaft 2. (2) Insert the shaft 1 in j, and attach the shaft 1 to i. (3) Attach the leaf spring, and then attach the plate. Fix the leaf spring and the plate by using the screw D.
D Leaf spring Plate
Fig.3-3a
Shaft 2 Part j
Part k
Shaft 1 Part i
Fig.3-3b 1-14 (No.YD008)
|