JVC HR-XV1EK
Manual de Usuario

Instant Timer Recording (ITR)
The instant timer recording feature provides a simple and convenient way to make a timed recording. Preparation: � Turn ON the TV and set to the video input mode. � Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then press VCR to select the VCR mode. (The VCR indicator will light)

1 Load a blank cassette tape with the
erase prevention tab intact. (The DVD/VCR will automatically turn on.)
VCR

2 Select the program (e.g.29) you want to record with PR +/� or
number keys. 1~9 : e.g. 5 = press �5� 10~80 : e.g. 29 = press �2� and �9�.
VCR

3 If a recording in Long Play mode is intended,28) press SPEED) to display "LP". (see note on page 4 Press 2 on the VCR or while holding 2, press

(TAPE

on the Remote to begin recording. Press 2 on the VCR again to stop recording after 30 minutes. Each additional press of 2 will increase recording time as shown in the chart below, up to a maximum of 5 hours. The ITR and ITR 0:30 recording time will appear on the CH 29 screen for about 4 seconds. And, STEREO SWF REC will keep blinking in the display.
VCR REC

�REC� will keep blinking in the display. Tape speed: SP Recording 5:00 0:30 4:00

INDEX

1:00 3:00 1:00 5:00

1:30 2:00 1:30 4:00 2:00 3:00

Tape speed: LP Recording 0:30 10:00 .......

To Extend the Recording Time
Note: � If you wish to watch the DVD playback during the ITR, press DVD to change to DVD mode and perform the DVD playback (see page 42). � If the tape supply has not sufficed for ITR recording, the clock symbol ( ) will blink at the tape-end and then VCR mode will change to DVD mode. In this case, press � to cancel the blink or press EJECT to remove the cassette tape. While holding 2, press . repeatedly until the desired time appears on the display.
ITR 1 : 30 CH 29 SWF

To stop the ITR
Press 3.

30