Recording
TV signals being received by the recorder�s built in tuner can be recorded onto a video tape. You can �capture� a TV programme using your VCR.
Choose a Programme
before you start
Turn the TV on Tune the TV to your Video Channel or to its AV mode Choose a blank cassette which has the record safety tab still in place
Press
PR
or
PR
or the number keys on the Remote Control to select the
channel that you wish to record.
Set the Tape Speed
Press /. The current setting for the tape speed appears on the on-screen display or the VCR display panel for about 5 seconds. Press /again to change the setting while tape speed is displayed. You can choose Standard Play (SP) or Long Play (LP). The picture quality on LP recordings will not be as high as on SP recordings, but the tape will last longer.
Record Safety Tab Load the cassette into the VCR (see page 14)
PR
Start Recording
There are two ways to start recording:
method one Press and hold T and then press . on the Remote Control. method two Press T on the VCR.
3
PR
Pause and Resume During Recording
AUDIO � �:� �
3 VPS/PDC
0000
5
?
30 SEC
On either the VCR or the Remote Control, press | to temporarily stop recording and press . to resume. You cannot change the preset position on the VCR while it is recording but you can while it is paused (see Choose a Programme at the top of this page).
