JVC HR-J745EK
Manual de Usuario

21
NOTES:
R E C O
q

� The B.E.S.T. system works for both SP and LP modes only after a tape has been inserted and the Record mode is first initiated. It does not work during recording. � In the case of timer recording, the B.E.S.T. system works before recording is initiated. � Once the cassette is ejected, the B.E.S.T. data is cancelled. The next time the cassette is used for recording, B.E.S.T. is reperformed.

PLAY

PAUSE

2

1 4 7

2 5 8 0

3 6 9
4

PLAY

R D

ATTENTION:
Since the B.E.S.T. system works before recording actually starts, there is a delay of approximately 7 seconds after RECORD and PLAY on the remote are pressed, or RECORD on the recorder is pressed. To make sure you record the desired scene or programme in its entirety, first perform the following steps: 1) Press and hold PAUSE and RECORD to engage the RECORD PAUSE mode. � The recorder then automatically checks the condition of the tape and, after approximately 7 seconds, reenters RECORD PAUSE. 2) Press PLAY to start recording. � If you want to bypass the B.E.S.T. system and begin recording immediately, set �B.E.S.T.� to �OFF� in step 4 on page 20.

Playback
The recorder assesses the quality of the tape once you initiate playback. When watching a tape recorded with �B.E.S.T.� set to �ON�, it is recommended that you leave B.E.S.T. on during playback as well.
PAUSE

START PLAYBACK

RECORD
3
1

1

Press PLAY. HR-J745EK

HR-J249EK

� The recorder adjusts the playback picture quality based on the quality of the tape in use. � B.E.S.T. is active during Auto Tracking. �BEST� appears blinking on the recorder�s display panel.

NOTES:

� When watching a rental tape or one recorded on another video recorder, or when using this recorder as the player for editing, set B.E.S.T. to your preference by performing steps 2 through 5 on page 20. � "BEST" only appears at the beginning of automatic tracking. Even though it doesn't appear after that, the B.E.S.T. function is operative.