SONY HDS-7150
Manual del propietario

Executing and Saving Effects

Execution with a combination of the fader lever and the RUN button
Fader lever operation during execution in auto mode If at an intermediate point of execution of an effect started by pressing the RUN button you operate the fader lever, when the fader lever reaches the position corresponding to the current position of the effect execution, the auto mode ends, the RUN button goes off, and the fader lever takes over control of the execution of the effect. Execution in auto mode during fader lever operation After executing part of the effect with the fader lever, if you stop moving the fader lever then press the RUN button, the effect execution resumes. At this point the effect duration setting applies to the duration of the whole effect. Therefore if set to 100 frames, for example, and if a portion of the effect corresponding to 25 frames has been executed with the fader lever, the remaining 75 frames are executed in auto mode.
Note

7 Keyframe Effects

If you stop the fader lever in an intermediate position and complete the effect, the position of the fader lever no longer agrees with the current position of the effect. All the LEDs of the effect progress indicator either light or go off, and in this state the fader lever does not function. To use the fader lever again, first move it to either end of its travel.

Moving to the first keyframe of the effect
Press the REWIND button to move to the first keyframe of the effect.

Pausing an effect at a desired point � PAUSE
It is possible to set a pause point so that an effect always pauses at that point. To restart the paused effect, move the fader lever once again or press the RUN button. Only one pause point can be set within the duration of the effect. When more than one sub-register is recalled, the effect execution follows the pause setting of the reference channel.
Note

A pause setting does not take effect if you start the effect by using an editor.

7-26

Chapter 7

Keyframe Effects