SHARP HC-2007
Manual de Servicio

HC-2040/C-2007 HC-2140/C-2107

DESCRIPTION OF SCHEMATIC DIAGRAM
SAFETY NOTES:
1. DISCONNECT THE AC PLUG FROM THE AC OUTLET BEFORE REPLACING PARTS. 2. SEMICONDUCTOR HEAT SINKS SHOULD BE REGARDED AS POTENTIAL SHOCK HAZARDS WHEN THE CHASSIS IS OPERATING.

NOTES:
1. The unit of resistance �ohm� is omitted. (K = 1000 ohms, M = Meg ohm). 2. All resistors are 1/16 watt, unless otherwise noted. 3. All capacitors are µF, unless otherwise noted. (P = µµF).

VOLTAGE MEASUREMENT CONDITIONS: IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH �å� ( ) ARE IMPORTANT FOR MAINTAINING THE SAFETY OF THE SET. BE SURE TO REPLACE THESE PARTS WITH SPECIFIED ONES FOR MAINTAINING THE SAFETY AND PERFORMANCE OF THE SET. 1. Voltage in parenthesis measured with no Signal. 2. Voltages without parenthesis measured with PAL Colour-Signal. 3. All the voltages in each point are measured high impedance voltmeter.

WAVEFORM MEASUREMENT CONDITIONS: SERVICE PRECAUTION:
THE AREA ENCLOSED BY THIS LINE ( ) IS DIRECTLY CONNECTED WITH AC MAINS VOLTAGE. WHEN SERVICING THE AREA, CONNECT AN ISOLATING TRANSFORMER BETWEEN TV RECEIVER AND AC LINE TO ELIMINATE HAZARD OF ELECTRIC SHOCK. 1. Colour bar generator signal of 1.8V peak to peak applied at Base of Video Buffer Amp. Q203. 2. Approximately 4.0 V AGC bias.

26