CRATE GTX212
Manual de Usuario

GTX120/212 Guitar Amplifier DSP & Channel Tracking

with

11

12

13

14

15

16

17

18

16: INSERT: Use this jack to connect an external effects device to the amplifier. Use a stereo 1/4� male Y connector: ring = send, tip = return, sleeve = ground. (Refer to the illustration at the bottom of page 5.) 17: EXTERNAL SPEAKER: Use this jack to connect an external speaker to the amplifier. This jack is wired in series with the internal speaker(s) which remain active when an external speaker is connected. 18: POWER: Use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed). The switch is illuminated when the amplifier is on. 19: AC LINE CORD (rear panel, not shown): This grounded power cord is to be plugged into a grounded power outlet, wired to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the rear panel. Do not attempt to defeat the safety ground connection. 20: FUSE (rear panel, not shown): The fuse protects the amplifier from damages caused by a faulty AC power source and/or other problems. If the fuse opens, replace it ONLY with the same size and type. If fuses continue to fail, check the AC source � if the source is okay, contact your Crate dealer for service information. 21: CHANNEL SELECT / GAIN FOOTSWITCH JACK (rear panel, not shown): Use this jack to connect the 1/4� stereo plug on the footswitch cable to the three-button footswitch (supplied). This allows you to remotely switch between the Clean and Rhythm/Solo channels and between Rhythm Gain 1 and Solo Gain 2 of the Rhythm/Solo channel. 22: REVERB FOOTSWITCH JACK (rear panel, not shown): Use this jack to connect the 1/4� mono plug on the footswitch cable to the three-button footswitch (supplied). This allows you to remotely turn the DSP function on and off. CONNECTING TO THE INSERT JACK: Stereo-to-mono Y-cord: Y-adapter and 2 cables:
to Insert jack
TIP

The Insert jack (#16) allows you to patch an external effects device into the amplifier prior to its power amp stage. Use Crate�s STP201, STP202 or STP203 stereo-to-mono Y cord or an adapter such as Crate�s YPP117 and two 1/4� mono signal cables to connect the effect as shown in the adjacent illustration.
(STP201, 3' STP202, 6' STP203, 9')

TIP RING SLEEVE

RETURN SEND GROUND

TIP RING SLEEVE

to Insert jack

(YPP117)

R ING

TIP

RING

(1/4"-TO-1/4" MONO CABLES)

to effect "OUT" jack

to effect "IN" jack

to effect "OUT" jack

to effect "IN" jack

External Effect

External Effect

5