JVC GRDX75EK
Manual de Servicio

<M2> UPPER ASS'Y(G)
C1 E

F 605 COVER(TOP/UPP)L COVER(TOP/UPP)R D1 C2 606 604 D2 J H C1 607 B 612 MONI.LOCK ASS'Y

611

MONITOR ASS'Y(G) (Refer to the Exploded view for this part.) 601 616 D1

SUB OPE UNIT

A

610 UPWARDS C2 U.CASE ASS'Y 602

(WR601a) F

617 PASTE

D2

FRAME(UPPER) ASS'Y E SOLDERING 2 POINT 603

G A 614 SCREW * SPEAKER 609 608 BRACKET(SPEAKER) * Mark*: This part was deleted on the way of production.

B

J H

G 613 CONCLUSION SCREW TORQUE TABLE PART.NO 611 ANOTHER SCREW TORQUE 0.2 ±0.01 N�m 0.08 ±0.01 N�m PROCESSING SUB OPE FPC. DRAWING FOR SPACER STICKING. 626 COVER(TOP/UPP)R COVER(TOP/UPP)L 615
VALLEY FOLDING VALLEY FOLDING MOUNTAIN FOLDING

UPPER ASS'Y(G) LYH20626
PROCESSING MONITOR FPC.

PROCESSING SUB OPE.

3 ±1 mm

VALLEY FOLDING AFTER PASTING SUB OPE PUSH TO THIS SLASH PART. MOUNTAIN FOLDING

SPACER(A)
DON'T STICK OUT SPACER IN SUB OPE FPC. VALLEY FOLDING

PASTE SPACERS NOT TO COVER THESE HOLES. STICK TO U.CASE. SHEET STICK ALONG THE REINFORCEMENT BOARD OF FPC. PASTE SPACER INSIDE BKT(UPPER). DON'T RUN A GROUND TO A LEVEL DIFFERENCE OF UPPER CASE. SOLDER 2 POINT MOUNTAIN FOLDING

SPACER(A) SPACER(A)

618 623
SHOULD BE COVERED THIS CONVEX.

SPACER(A) 620
DON'T STICK OUT SPACER IN UPPER CASE. LESS THAN 0.5mm

3 ±1 mm

STICKER

625

624 SPACER(A) 621

SPACER(A)

SHEET STICK ALONG THE CORNER OF FRAME. STICK FPC SO THAT THERE MAY BE NO CREVICE BET MEEN THE HOLE OF IT IN THE RIGHT SIDE OF THE HOLE RING.

PASTE SPACER THIS CONVEX IN UNDER SIDE. DON'T BE SEEN SPACER OUTSIDE OF UPPER CASE.

THE SIDE OF THE HOLE RING IS MET. THESE HOLES CAN BE SSEN.

619
DON'T RUN A GROUND OF UPPER CASE. DON'T SEPARATE.

SPACER(A) SHEET(SHIELD) 622
STICK SPACER THAT FPC MAY BE PRESSED DOWN.

Fig. 1-2-2c UPPER ASS�Y(G)

1-5