TROUBLESHOOTING (Cont.)
POSSIBLE CAUSES
36. �The LCD monitor or the viewfinder is made with high-precision technology. However, black spots or bright spots of light (red, green or blue) may appear constantly on the LCD monitor or the viewfinder. These spots are not recorded on the tape. This is not due to any defect of the unit. (Effective dots: more than 99.99 %) 37. �During playback of the unrecorded portion, Highspeed Search and still playback, LCD monitor indications appear distorted. This is not a defect. 38.
����
SYMPTOM
36. Coloured bright spots appear all over the LCD monitor or the viewfinder.
CORRECTIVE ACTION
36.
����
37. The LCD monitor indications are distorted.
37.
����
38. An unusual mark appears in the LCD monitor or the viewfinder. 39. An error indication (E01 � E06) appears in the LCD monitor or the viewfinder.
38. � Check the section of the manual that explains LCD monitor/viewfinder indications ( pgs. 79 � 81). 39. � Remove the power supply (battery pack, etc.) and press RESET button, and wait a few minutes for the indication to clear. When it does, you can resume using the camcorder. If the indication remains even though you repeat the above two or three times, please consult your nearest JVC dealer. 40. � To protect the battery, it is recommended to charge it in places with a temperature of 10°C to 30°C ( pg. 9). 41.
����
39. �A malfunction of some kind has occurred. In this case the camcorder�s functions become unusable.
40. The charge indicator on the AC Charger Station does not light. 41. The recording mode indicator �LP� blinks on the LCD monitor or the viewfinder.
40. �The temperature of the battery is extremely high/low. �Charging is difficult in places subject to extremely high/ low temperatures. 41. �This occurs when recording in the LP mode is not available. After the indicator blinks, the recording mode switches to �SP� and recording goes on. 42. �The viewfinder is pulled out. �The LCD monitor�s brightness setting is too dark.
42. Picture does not appear on the LCD monitor.
42. � Push the viewfinder back in. � Adjust the brightness of the LCD monitor ( pg. 22). � If the monitor is tilted upward 180 degrees, open the monitor fully ( pg. 23). 43. � By recording with Digital Image Stabilizer set to �ON� ( pg. 32) this can be avoided.
43. When the image is printed from the printer, a black bar appears at the bottom of the screen.
