USING REMOTE CONTROL UNIT (GR-AX847 only) (cont.)
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged. FF STOP
COUNTER R/M PLAY/PAUSE REW
NOTE:
Use the RM-V705U or RM-V700U remote control unit to perform this procedure.
SELECT MODE
1 2
Power Switch
Set the Power Switch to �PLAY�.
FIND EDIT-OUT POINT RESET COUNTER
Play back the tape, locate the point and press PAUSE on the camcorder or the remote control. Press and hold COUNTER R/M for more than 1 second to reset the tape counter, then press again for less than 1 second and make sure �M� appears.
3 4 5 6 7
Insert editing indicator
FIND EDIT-IN POINT
Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the point where the new scene should start.
M�0:12:34
Tape Counter
ENGAGE INSERT EDITING MODE
Viewfinder Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.
BEGIN INSERT EDITING
Press START/STOP. When the counter reaches �0:00:00�, editing stops automatically and the camcorder enters the Insert-Pause mode.
END INSERT EDITING
Press STOP.
START/STOP REW PLAY PAUSE REW INSERT RM-V700U (optional) OR RM-V705U (provided with GR-AX847 only)
NOTES:
� After step 5, Retake ( pg. 19) can be performed. � The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit. � Only video signal is recorded in the Insert Editing mode.
