USING REMOTE CONTROL UNIT (GR-AX720 only) (cont.)
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.
COUNTER R/M
NOTE:
Use the RM-V705U or RM-V700U remote control unit to perform this procedure.
SELECT MODE
1 2
POWER
Set the Power switch to �PLAY�.
FIND EDIT-OUT POINT RESET COUNTER
Play back the tape, locate the point and press PAUSE on the camcorder or the remote control. Press and hold COUNTER R/M for more than 2 seconds to reset the tape counter, then press for less than 1 second and make sure �M� appears in the viewfinder.
3
M-1:23:45
Tape Counter Insert editing indicator
FIND EDIT-IN POINT
Viewfinder
4 5 6
START/STOP REW PLAY PAUSE REW INSERT
Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE at exactly at the point where the new scene should start.
ENGAGE INSERT EDITING MODE
Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged, and the scene the camcorder is aimed at appears on the screen.
BEGIN INSERT EDITING
Press RECORDING START/STOP. When the counter reaches �0:00:00�, editing stops automatically and the camcorder enters the Insert-Pause mode.
END INSERT EDITING
7
Press STOP.
NOTES:
� After step 5, Retake ( pg. 16) can be performed. � The tape may stop slightly before or after the
RM-V700U (optional)
OR
RM-V705U (provided with GR-AX720 only)
designated end point, and noise bars may appear. Neither indicates a defect in the unit. � Only video signal is recorded in the Insert Editing mode.