- Removing the Case and Panel
1. Remove six screws A, and then remove case. 2. Remove panel.
A
Panel
Case
Fig. 6
- Removing the Amp Unit
B C
Sub Heat Sink
Some silicone glue has been applied between the Heat sink and the Sub Heat Sink. therefore, to remove the Amp Unit from the Heat Sink. 1. Remove four screws B and Three screws C. 2. Use 2 pcs. of screw B and insert them into the two holes marked with an arrow. 3. Alternately tighten them little by little until the Sub Heat Sink separates from the Heat Sink.
