PIONEER GM-6300T
Manual de Usuario

MAN-GM-6300T-GB.fm Page 4 Thursday, November 16, 2006 4:23 PM

Setting the Unit
Gain Control

4

ENGLISH

Adjusting the gain controls A and B will help match the output of the car stereo to the Pioneer amplifier. Normally, set the gain controls to the NORMAL position. If the output is low, even when the volume of the car stereo is turned up, turn these controls clockwise. If there is distortion when the volume of the car stereo is turned up, turn these controls counterclockwise.

Power Indicator
The power indicator lights when the power is switched on.

� If you only use one input plug, set the gain controls for speaker outputs A and B to the same position. � When using with an RCA equipped car stereo (standard output of 500 mV), set to the NORMAL position. When using with an RCA equipped Pioneer car stereo with max. output of 4 V or more, adjust level to match the car stereo output level.

BFC (Beat Frequency Control) Switch
If you hear a beat while listening to an MW/LW broadcast with your car stereo, change the BFC switch using a small standard tip screwdriver.

LPF (Low-Pass Filter)/HPF (High-Pass Filter) Select Switch
Set the LPF/HPF select switch as follows according to the type of speaker that is connected to the speaker output connector and the car stereo system: LPF/HPF Select Switch
LPF (Left)

Audio frequency range to be output
80 Hz and below with �12 dB/ oct. cut off slope Full range 80 Hz and above with �12 dB/ oct. cut off slope

Speaker Type
Subwoofer Full range Full range

Remarks
Connect a subwoofer.

Input Select Switch
For two-channel input, slide this switch to the left. For four-channel input, slide this switch to the right.

OFF (Center) HPF (Right)

Use if you want to cut the very low frequency range because it is not necessary for the speakers you are using.