22. EFFECTS LOOP LINE OUT: When using an external effects processor, connect this jack to the input of the effect by means of a shielded signal cable. This jack also doubles as a source for a post-EQ, preamp signal to send your signal to a mixing board, recorder, powered monitor or external amplifier. 23. EFFECTS LOOP LINE IN: When using an external effects processor, connect this jack to the output of the effect by means of a shielded signal cable. This jack also doubles as a direct connection to the power amp, bypassing the input and preamp stages. This is useful for �slaving� a pair of amplifiers together.
24. SPEAKERS: Use these jacks to connect the amplifier to your speaker cabinet(s) using speaker cables with mono 1/4� plugs. These jacks are wired in parallel. Make sure that the combined impedance of your speakers is equal to or greater than 2 ohms! Use the chart below to help determine parallel loads. If in doubt, ask your dealer.
CAB IMP 4 ohms 8 ohms 8 ohms 16 ohms 16 ohms 16 ohms # CABS TOTAL IMP 2 2 4 2 4 8 2 ohms 4 ohms 2 ohms 8 ohms 4 ohms 2 ohms
25. POWER CORD: This grounded power cord is to be plugged into a grounded power outlet, wired to current electrical codes and compatible with the voltage, power, and frequency requirements stated on the rear panel. Don not attempt to defeat the safety ground connection.