FUJI FinePix S100FS
Manual de Usuario

[SHOOTING MENU]

Setting the menu (�p.85) Set the exposure compensation again, using a negative value (�) when [OVER] appears and a positive value (+) when [UNDER] appears (�p.66).

Custom white balance
ISO 100

A Select [ CUSTOM 1] or [ CUSTOM 2] (�p.85). B Hold a piece of white paper under the light source for setting the white balance, so that it fills entire the frame in the screen. Then press the shutter button to set the white balance.
CUSTOM WB

OVER

F

[OVER] or [UNDER] Example
You can change the white balance for a photographed image by using colored paper instead of white paper.
NEW WB NOT CHANGE CANCEL

MEMO
To use the white balance set previously, press MENU/OK without pressing the shutter button.

MEMO
� In AUTO mode, the correct white balance may not be achieved for subjects such as close-ups of people�s faces and pictures taken under a special light source. Select the correct white balance for the light source. � When the flash fires, the white balance (except for custom white balance) setting for the flash is used. Consequently, to achieve a particular effect, the flash mode should be set to Suppressed flash (�p.77). � The specified custom white balance is retained until it is reset. This setting is retained even if the battery is removed. � The color tones may vary depending on the shooting conditions (light source, etc.). � After taking the picture, check the image color (white balance). � Explanation of Terms �White Balance� (�p.171) � Use the same ISO setting when custom white balance was set, before shooting.

C When the correct exposure is measured, [COMPLETED!] appears. Press MENU/OK to confirm the setting.
COMPLETED!

SET

CANCEL

92