Recording
CD Synchro Start Recording 1
Load a blank tape into tape deck 2 and a disc into a disc tray. 2 Press CD to select CD mode. ¶ You can programme the tracks in the order you want them to be recorded (see Programming Tracks). If not, select the disc by pressing CD (CD 1�2�3) and the tracks are recorded according to the order on the selected disc. 3 Press RECORD to start recording. � The REC starts flashing. ¶ Disc will start playback automatically. 4 Press � to stop recording.
Recording from other sources
(only on tape deck 2) 1 Load a blank tape into tape deck 2 with the open side downward. 2 Press CD, TUNER or AUX. ¶ Start playback of the selected source. 3 Press RECORD to start recording. � The REC starts flashing. 4 Press � to stop recording. Notes: � During recording, it is not possible to listen to another source.
Dubbing tapes (from tape deck 1 to tape
deck 2) 1 Press TAPE ( TAPE 1�2 ) to select tape deck 2. 2 Load the prerecorded tape into tape deck 1 and a blank tape into tape deck 2 with full spool to the left. 3 Press DUBBING. � "DUB" with "2" scrolling right will be displayed. ¶ Dubbing will start immediately. � The REC starts flashing. 4 Press � to stop dubbing. Notes: � At the end of side A, flip the tapes to side B and repeat the procedure. � Dubbing of tapes is only possible from tape deck 1 to tape deck 2. � To ensure good dubbing, use tapes of the same length. � You can switch to other source while dubbing.
23
pg 01-28/C200/21-Eng 23 29/05/2001, 10:13 AM 3139