ZANUSSI FV832
Manual de Usuario

Installation
Unpacking
All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1. Using a spanner, unscrew and remove the two rear bottom screws. Slide out the two plastic pins. 6. Set the machine upright and remove the remaining rear screw. Slide out the relevant pin. 7. Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet.

P1128

P0002

Positioning and levelling
P1129

P0001

2. Lay the machine on its back, taking care not to squash the hoses. This can be avoided by placing one of the corner packing pieces between the machine and the floor. 3. Remove the polystyrene block from the bottom of the machine and release the two plastic bags.
1 2 3

Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Carefully level by screwing the adjustable feet in or out. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor.

P1124

4. Very carefully slide out the left polythene bag, removing it towards the right and then downwards. 5. Very carefully slide out the right polythene bag, removing it towards the left and then upwards.

P1051

Water inlet
Connect the water inlet hose to a tap with a 3/4" thread.

P1126

P1127
P1088

5

ENGLISH