6. Remove the front [A] and rear [B] covers from the expansion unit (2 screws each). 7. Adjust the height of the paper bank: a. Remove the internal cover [C] from the paper bank (2 screws). b. Using the height adjusting bolts [D], raise or lower the paper bank so that both the front [E] and rear [F] screw holes of the paper bank and expansion unit align. c. Secure the paper bank to the expansion unit (2 screws). d. Open the system table front door [G], swing out the 4th paper feed station [H], and secure the paper bank to the front side of the system table (1 screw). e. Remove the bank rear cover [I] and the bank rear right cover [J] (2 screws each), then secure the bank to the rear side of the system table (1 screw). f. Install the bank docking bracket [K] (2 screws). g. Install the internal cover to the paper bank (2 screws). 8. Install the front [L] and rear [M] expansion docking plates as shown (2 screws each).
