ZANUSSI F655G
Manual de Usuario

Operating sequence
Before washing your first load of laundry, we recommend that you run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine.

4. Select the desired option(s)
Depress the required button(s).

1. Place the laundry in the drum
Open the door. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door.
95

5. Select the temperature
Turn the dial to the required setting.

M0045
P0004

6. Select the programme and start the machine
Turn the programme selector dial clockwise to the required programme and press the ON/OFF button: the mains on light comes on and the machine starts to operate.

2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure out the amount of detergent recommended by the manufacturer in a graduated cup and pour it into the main wash compartment . If you wish to carry out a programme with prewash, pour detergent into the appropriate compartment marked .

B

3. Measure out the additive
M0046
P0080

If required, pour fabric softener into the compartment marked , without exceeding the «MAX» mark.

7. At the end of the programme
The machine stops automatically. If you have depressed the ANTI-CREASE button, the machine will stop with the water left in the tub, to prevent the fabric from creasing. To drain the water and spin, release the same button. To drain only, select programme �N�.

C0064

C0065

The door is controlled by a safety device which releases 2 minutes after the end of the programme. Switch the machine off by depressing the ON/OFF button again. The mains-on light goes out. When the programme has finished you are advised to unplug the appliance and turn off the water tap. 10