PANASONIC EY6450
Manual de Usuario

Attaching or removing bit
NOTE: When attaching or removing a bit, disconnect battery pack from tool or place the switch in the center position (switch lock). This tool is equipped with a keyless drill chuck. 1. Attachment Insert the bit and turn the lock collar clockwise (looking from the front) to tighten firmly until it stops clicking.

.ASSEMBLY

Attaching or removing battery pack
1. To connect the battery pack: Insert the battery pack. It snaps into place to indicate proper connection. 2. To remove the battery pack: Press the two buttons on the sides of the battery pack. Slide the battery pack out of the tool body.

Support handle
Place the support handle at your favorite position and tighten the handle securely.

2. Removal Turn the lock collar counterclockwise (looking from the front), then remove the bit.

Lock collar

Loosen

Tighten

Remove the handle when placing the tool in the storage case.

.OPERATION
3. Storage Keep the bit in bit holder when not in use. Remove the battery pack to expose the bit storage compartment inside the handle housing. Bits up to 50 mm (1-31/32 inch) long can be stored here. NOTE: If excessive play occurs in the chuck, secure the drill in place and open the chuck jaws by turning the lock collar and tighten the screw (lefthanded screw) with a screwdriver by turning it counterclockwise (viewed from the front).

Switch Operation

1. The speed increases with the amount of depression of the trigger. When beginning work, depress the trigger slightly to start the rotation slowly. 2. A feedback electronic controller is used to give a strong torque even in low speed. 3. The brake operates when the trigger is released and the motor stops immediately. NOTE: When the brake operates, a braking sound may be heard. This is normal.

Forward / Reverse lever Operation

(Forward ( ), Switch lock, Reverse ( ))

-7-