EMERSON EWR20V5
Manual de Servicio

Recording
One-touch Timer Recording
Video VR

This is a simple way to set the recording time in blocks of 30 minutes. Check that the disc has enough recordable space for the time you set. After finishing the recording, the recorder automatically goes into standby. First:
DVD

DVD-RW

DVD-RW

DVD-R

4
Using [CH K / L] or the Number buttons, select a desired channel to record.
POWER T-SET ABC JKL TUV SPACE OPEN/CLOSE TIMER PROG. DEF MNO WXYZ CLEAR GHI PQRS

.@/: 1 4 7

2 5 8 0

3 6 9

CH
VIDEO/TV SETUP

4

5
Hit [REC/OTR] repeatedly to select a desired recording time. Recording time appears on the TV screen (30 minutes to 8 hours). Recording will start.

DISPLAY

TOP MENU MENU/LIST

RETURN

ENTER

1
Turn on the unit and load a recordable disc. Make sure that the TV input is set on the unit. This operation may take a while to be recognized.

REC SPEED

REC/OTR

VCR

PLAY

DVD

REC/OTR

5 5

2

REC MONITOR SLOW DUBBING

SKIP CM SKIP ZOOM

PAUSE
STOP

SKIP SEARCH

AUDIO

I

0:30

Note
0:30

2
Using [REC SPEED], select a recording speed. Refer to �Recording speed� on page 25.
(Normal Recording) 1:00

� The remaining recording time will appear on the display panel during an one-touch Timer Recording. Hit [DISPLAY] to see it on the TV screen. � You cannot pause a one-touch Timer Recording. � Unlike a Timer Recording, you can perform the following operations during a one-touch Timer Recording. - Turning off the power. - Using [REC/OTR] and [STOP C]. � The unit will be turned off automatically under the following conditions. 1)No space remained on the disc. 2)When a power failure occurs. � If OTR is finished in DVD during playback or REC mode in VCR, the DVD will be in STOP mode and the VCR keeps the current mode. � When OTR is finished and the power is turned off, the unit will switch to the standby mode automatically if a Timer Recording has been programmed. Hit [T-SET] to cancel the standby mode for using the unit continuously.

8:00

7:30

3
Make sure that the recording format is set to the desired mode. Refer to �Formatting a disc� on pages 27-28. When a DVD-RW disc is loaded: You can choose Video mode or VR mode from the Setting menu. �Video mode� has been selected as the default. Refer to page 27 �Choosing the recording format of a blank disc.� When a DVD-R disc is loaded: DVD-R discs will always be in Video mode.

When the unit reaches the specified time, it will turn off automatically. To change the recording time during the one-touch Timer Recording, hit [REC/OTR] repeatedly until the desired time appear. To cancel the one-touch Timer Recording within the specified time, hit [STOP C]. This operation may take a while to be completed.

30