EMERSON EWC13D4
Manual de Servicio

TV SECTION

SET UP FOR USE
SELECTING THE LANGUAGE
TV

CHANNEL SET UP
TV
You can program the tuner to scan all the channels you receive in your area. NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the TV/DVD channel selector to the output channel of the cable box or satellite box (Ex CH3), then select the channel to be viewed on the Cable Box or Satellite Box. Make sure ... � Press POWER to turn on the TV/DVD.

1

Plug in the TV/DVD power cord

Plug the TV/DVD power cord into a standard AC outlet. NOTE:

� If any digits appear in the corner of
the screen, press POWER without unplugging the power cord. Make sure ... � Press POWER to turn on the TV/DVD. NOTE: This function effects only the language on the screen menu and not the audio source.

1 2
Select �LANGUAGE�
- TV SETUP CHANNEL SET UP V-CHIP SET UP B LANGUAGE [ENGLISH] CAPTION [OFF]

Select �CHANNEL SET UP�
- TV SETUP B CHANNEL SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF]

Press SETUP on the remote control. Press Arrow (K/L) to point to �LANGUAGE�.

Press SETUP on the remote control. Press Arrow (K/L) to point to �CHANNEL SET UP�. Then press ENTER.

3

Select �ENGLISH�, �ESPA�OL� or �FRAN�AIS�

2

Begin auto ch programming
� CHANNEL SET UP � ADD / DELETE CH (CATV) B AUTO CH PROGRAMMING

Select �ENGLISH�, �ESPA�OL�= Spanish or �FRAN�AIS�= French using ENTER.

Press Arrow (K/L) to point to �AUTO CH PROGRAMMING�. Then press ENTER. The tuner scans and memorizes all the active channels in your area.

4

Exit the Language mode

Press SETUP to return to TV mode. NOTE: If for some reason the menu is in Spanish or French, press SETUP, press Arrow (K/L) to point to �IDIOMA [ESPA�OL]� or �LANGAGE [FRAN�AIS]�, then press ENTER, then press SETUP on the remote control.

3

After scanning

The tuner stops on the lowest memorized channel. � When AUTO CH PROGRAMMING is activated where there is no TV signal input, �NO TV SIGNALS� will appear on the display after the completion of the channel scanning. � The TV/DVD may recognize TV channels to be CATV channels by the receiving conditions. In this case, try auto ch programming again in the fine receiving conditions.

� 13 �

0C28

EN