You can change the hinges on your refrigerator so the doors open the other way, Refer to the instruction sheet included with your refrigerator.
Changing
the light bulb...
WARNING: Before removing a light shield for cleaning or for replacing the bulb, unplug the refrigerator or turn off the electrlclty leadlng to the refrlgerator at the maln power supply. Shock and Injury could occur. Light bulb behind light shield:
1. Push lightly on top center of the light shield until the notched tab unhooks from the control panel 2. Pull down on the shield until the tab clears the control panel. 3. Lift the back hooks out of the slots. 4. Replace with a 40.watt appliance bulb 5. Replace light shield in reverse order
Optional
automatic
ice maker.. .
l
l
lower Slgnal Arm to Start It.
l
I r&e :on Al 7
Ra ise Signal Arm to Stc,p Ice Maker. -.
l
l
It is normal for ice crescents to be attached by a corner. They will break apart easily. You will hear water runnina when ice maker is working. You�ll hear ice fall%to the bin. Don�t let these sounds bother you. The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice. If Ice is not being made fast enough and more ice is needed, turn the Temperature Control toward a higher number. Wait a day and, If necessary. turn the Air Control toward A. If you remove the Ice brn, raise the signal arm to shut off the ice maker. When you return the bin, push it all the way in and lower the arm to the ON posrtion. If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes In the ice brn can also become smaller by evaporation. The ice maker water supply should not be softened water. The chemicals could damage the ice maker molds.
l
If you have the automatic ice maker accessory or plan to add one later (Part No. ECKMF-61). there are a few things you will want to know: l The ON/OFF lever is a wire srgnal arm. Down...fcr making ice automattcally. Up...toshut off the ice maker. l Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacrty.
l
l
Removing
the base grille..
.
Support
l l
Tabs
Pull grille outwards
as shown
To replace:
l l l
Do not remove Tech sheet fastened behind grille
Line up grille support tabs wtth metal clips Push firmly to snap into place. Close the door.
