WHIRLPOOL ET18YKXAW00
Manual de Usuario

Using

the ice cube trays

If cubes are not used. they may shrink. The moving cold air starts a slow evaporation. The longer cubes are stored, the smaller they get. To remove ice: 1. Hold tray at both ends. 2. Twist slightly.

Using

the optional

automatic

ice maker

If you have an automatic ice maker accessory, or if you plan to add one later (Part No. ECKMF-90), there are a few things you will want to know: . The ON/OFF lever is a wire signal arm. Down . . . to make ice automatically. Up . . . to shut off the ice maker. .. NOTE: Do connected to the water sum& lnstructlons fcx water su~@y hook up are at tached to the back of the refrigerator cabinet. The dial or lever on the side of the ice maker changes the size of the cubes. Shake the bin occasionally to keep cubes separated and to obtain increased storage capacity. It is normal for ice crescents to be attached by a corner. They will break apart easily. You will hear water running when ice maker is working. You�ll hear ice fall into the bin. Don�t let these sounds bother you. The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections, the first ice may be discolored or off-flavored. Discard the first few batches of ice. If ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward A. If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin, push it in all the way and lower the signal arm to the ON position. If cubes are stored too long, they may develop an off-flavor . . . like stale water. Throw them away. Ice maker will make new ice. Cubes in the ice bin can also become smaller by evaporation.

Raise signal arm to stop ice. Lower signal arm to start it.

l

l

l

l

l

l

l

l

l

11