SHARP ER-A410
Manual de Usuario

8 Installing the fixing angle bracket
To prevent the register from moving when the drawer opens, the fixing angle bracket is supplied with the register. By attaching the bracket to the table where the register is installed, you can hock the register on this bracket and secure the register to its position. How to install the fixing angle bracket

1. Thoroughly clean the location where the fixing angle bracket
(B) is to be placed. 2. Peel off the adhesive tape on the fixing angle bracket. 3. Hook the angle bracket onto the hook (A) that is located at the bottom rear of the register. 4. Firmly stick the fixing angle bracket to the table surface that your cleaned above.

How to remove the register from the fixing angle bracket

1. Lift up the front of the register and pull the register towards
you.

164