PANASONIC ER224
Manual de Usuario

raise the moving blade, and brush the cut hairs out from between the blades. (see fig. 18) 4. Apply a few drops of the oil to the points indicated by the arrows. (see fig. 16) 5. Remount the blade on the trimmer body.

(

ATTENTION: A nickel cadmium battery that is recyclable powers the product you have purchased. Please call 1-800-8-BATTERY for information on how to recycle this battery.

)

7. Remove the two screws (l) and disconnect the rubber push plate (m). (see fig. 21) 8. Remove the screws (n) and disconnect housing (o). 9. Disconnect the battery chamber (p) and remove the battery (q). (see fig. 22)

Blade life
Blade life will vary according to the frequency and length of use. For example, using the unit for 10 minutes every 3 days, the life expectancy is approximately 3 years. If cutting efficiency is reduced substantially despite proper maintenance, the blades have exceeded their service life and should be changed. The replacement par t no. is WER9602. How to remove the built-in rechargeable battery before disposal of the trimmer The battery in this trimmer is not intended to be replaced by consumers. However, the battery may be replaced at an authorized service center. The procedure described below is intended only for removal of the rechargeable battery for the purpose of proper disposal. Always make sure that the battery have been removed from the trimmer before disposing of it. 1. Disconnect the adaptor from the AC outlet, and remove the power cord from the trimmer. 2. Remove the blade from the trimmer. Remove the screw (a) and detach the bottom cover (b). (see fig. 19) 3. Detach the dial cover (c), remove the screw (d) and disconnect the dial (e). 4. Remove the two screws (f). 5. Detach the housing (g), front panel (h) and side panel (i), then remove the trimmer drive rod (j) (see fig. 20). 6. Remove the two screws (k).

Attention
� Do not charge the trimmer at temperatures below 0°C (32°F) or above 40°C (104°F), or where it will be exposed to direct sunlight, or other heat sources. � Do not continue charging for more than 48 hours. Doing so may damage the battery. � Clean the housing only with a soft cloth slightly dampened with water or soapy water. Never use a caustic cleaner such as benzene or bleach. � The trimmer may become warm during operation and normal recharging. This is normal.

Battery life
Battery life will vary according to the frequency and length of use. If the battery is charged 3 times a month, the service life will be approximately 6 years. If the unit is left without being charged for more than 6 months, the charge will drain from the battery and their service life may be shortened. Therefore, even when not using regularly, it is recommended that the unit be recharged at least once every 6 months.

Caution
1. Keep out of reach of children. 2. Never tamper with the moving parts. 3. Do not pick up the trimmer by the cord. It may become detached, causing damage or injury. 4. Do not use on animals. 5. Never disassemble the trimmer. Take it to a qualified serviceperson when service or repair is required. 6. Do not attempt to use any power cord or adaptor other than one

specifically designed for this model. Use only the included AC adaptor. 7. Do not pull, twist or severely bend the power cord. 8. Do not wrap the power cord tightly around the appliance. 9. Dry the trimmer completely before charging it. 10. Keep the adaptor away from water and handle it only with dry hands. 11. Store the adaptor in a dry area where it will be protected from damage. 12. Wash the trimmer in tap water. Do not use salt water or boiling water. Also, do not use cleaning products that are designed for toilets, bathrooms or kitchen appliances. Do not submerge the trimmer for a long time. 13. Do not take the housing apart as this can affect the watertight construction. 14. Do not clean with water when the trimmer is connected to the power cord. 15. This power unit is intended to be correctly oriented in a vertical position or floor mount position. This product is intended for household use only.

Specifications
Power source: 120 V AC, 60 Hz Motor voltage: 1.2 V DC Charging time: 8 hours

10

11