Defrosting
While in operation the **-star compartment becomes progressively covered with frost. This frost, which acts as an insulator and thus prevents the cold from reaching the food should be removed whenever the thickness of the frost exceeds 1/4�. To carry out complete defrosting proceed as follows: 1. Push the conveyor completely in. 2. Place a tray on the upper shelf of the refrigerator under the drain hole of the conveyor. 3. Remove any food from inside the **-star compartment, wrap it in several sheets of newspaper and store in a cool dry place. 4. Turn the thermostat knob on position << 0 >>. To accelerate defrosting, place a bow of hot water inside the compartment (with a piece of cardboard underneath the bowl as protection). 5. When defrosting is completed, dry thoroughly and remove the water collected in the tray. Turn the thermostat knob on a medium position to restart the appliance. After letting the appliance run for at least half an hour replace the previously removed food into the ** -star compartment. When defrosting it is not necessary to remove the foods from the inner door and the refrigerator compartment.
Important
A temperature rise of the frozen food packs during defrosting may shorten their storage life. Never use sharp metal tools to scrape off frost from the evaporator as youcould damage it beyond repair.
Changing the Light Bulb
Should the light fail to work you can change it as below: Disconnect the appliance from the electricity supply. Remove the lamp cover retaining screws, then take the lamp cover off in the direction of the arrow and the bulb can be changed. (Type of the bulb: 230 V, 15 W, E 14 thread) After changing the bulb replace the lamp cover, and retaining screws and reconnect the appliance to the electricity supply.
When the appliance is not in use
When the appliance is not in use for long periods disconnect from the electricity supply, empty all of the food and clean the appliance, leaving the door ajar to prevent unpleasant smells. 9
