3. Fit the belt in position and secure Scanner Motor M4 (three screws).
1149D040AA
4. Hook the length of cable on the left (looking at the copier from the rear), around Pulleys C and B and secure it to the frame.
1149D041AB
5. Peeling off the tape, pull the length of cable on the right (looking at the copier from the rear) and hook it onto Pulleys A and B.
1149D042AA
NOTE � Hook the length of cable on the left (looking at the copier from the rear) onto the lower groove in Pully B. (Fit the round terminal as illustrated on the left.) � Hook the length of cable on the right (looking at the copier from the rear) onto the upper groove in Pulley B.
1149D043AA
6. Fit the cable into the groove in the cable guide and hook the spring. 7. Mount PWB-A (four screws).
