SHARP EL-2910R
Manual de Servicio

4. PAPER ROLL REPLACEMENT
Never insert paper roll if torn. Doing so will cause paper to jam. Always cut leading edge with scissors first. 1. Insert the leading edge of the paper roll into the opening. (Fig.1)

After battery installation
� Connect the power supply plug to an outlet and turn the power switch "ON". Check that "0." is displayed. If "0." is not displayed, remove the battery, reinstall it, and check the display again. � On the battery replacement data label found on the back of the unit, write down the month and year when the battery is installed, as a reference for the next battery replacement.

Fig.1 2. Turn the power on and feed the paper by pressing . (Fig.2)

6. REPLACEMENT OF BATTERY FOR MEMORY PROTECTION
Time for battery replacement
Replace with a new battery once 2 year.

Method of battery replacement
Use one lithium battery (CR2032). Fig.2 3. Insert the paper roll to the paper holder. (Fig.3) Note: When replacing the battery, the set tax rate and the memory contents will be lost. You may want to write down the tax rate and other important numbers on a sheet of paper. 1) Turn the power switch "OFF" and unplug the power supply plug from the outlet. 2) Remove the battery cover on the back of the unit. (Fig.1) Fig.3 Caution: Do not pull paper backwards as this may cause damage to printing mechanism.
1

5. INSTALLING OF BATTERY FOR MEMORY PROTECTION
Before using for the first time, remove the attached lithium battery, and install it in the equipment according to the following procedure. If the power cord is unplugged by accident when operating with AC power only, the set tax rate and the contents of memory will be lost. 1) Turn the power switch "OFF" and unplug the power supply plug from the outlet. 2) Remove the battery cover on the back of the unit. (Fig. 1)

2

Fig.1 3) Remove the exhausted battery and install one new lithium battery. Wipe the battery well with a dry cloth and place the plus "+" side upward. (Fig.2)

Fig.2 4) Replace the battery cover by reversing the removal procedure. 5) Press the RESET switch on the back of the unit.
1 2

After battery replacement
� Connect the power supply plug to an outlet and turn the power switch "ON". Check that "0." is displayed. If "0." is not displayed, remove the battery reinstall it, and check the display again. � Reset the tax rate. � On the battery replacement data label found on the back of the unit, write down the month and year when the battery is replaced, as a reference for the next battery replacement.

Fig.1 3) Wipe the battery well with a dry cloth and place the plus "+" side upward. (Fig. 2)

Fig.2 4) Replace the battery cover by reversing the removal procedure. 5) Press the RESET switch on the back of the unit.
EL-2910R PAPER ROLL REPLACEMENT

�3�