WHIRLPOOL EHT141XKWR0
Manual de Usuario

Removing

the light

Shield.

You may want to remove the light shield when cleaning, or for changing the bulb. First, unplug the refrigerator. Then, push lightly on the upper center of the shield until the notched tab is free from the console. Pull down until the tab clears, then lift the back hooks out of their slots. To replace it, do the reverse.
, Push in the Center; Pull Down

Ice Cube

Trays.

To remove ice from the flexible ice trays, hold a tray at both ends, as shown. Slightly twist the tray; the ice will come out easily. If cubes are not used for a number of weeks, they may become smaller. The moving air is so cold that it starts a slow evaporation. (That�s also why it�s so important to wrap food carefully.] The longer they are stored, the smaller they can get.

Optional
A Twist of the Wrists

ICE MAGIC@ Automatic

Ice Maker.

Raise Signal Arm to Stop Ice Maker. Lower Signal Arm to Start It.

If you have the automatic ice maker accessory (Part No. ECKMF-5), or plan to add one, there are a few things you will want to know: l On the side of your ice maker is a wire signal arm. When it�s down, the ice maker will make ice automatically. Raise the arm to shut off the ice maker. l Shake the bin occasionally to keep cubes separated, and to obtain increased storage capacity. It is normal for the cubes to be attached by a corner. They will break apart easily. l You will hear water running when the ice maker is working. You�ll hear ice fall into the bin. Don�t let these new sounds bother you. l The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. l Because of new plumbing connections, the first ice may be discolored or off-flavored. l Your ice maker will work faster when the freezer is colder. If you want more ice, turn the Temperature Control dial to a higher number, or turn the Air Control dial toward a higher number. l If you remove the ice bin, make sure you raise the signal arm to shut off operation. When you put the bin back, make sure it�s all the way in and the arm is lowered. l If cubes are stored too long, they may develop an off-flavor...like stale water. Throw them away. They will be replaced. Cubes in the ice bin can also become smaller by evaporation.

Sounds you may hear.
Your new refrigerator may make sounds that your old one didn�t. Because the sounds are new to you. you mtght be concerned about them. Don�t be. Most of the new sounds are normal. Hard surfaces like the Possible Sounds: Slight Hum; Soft hiss: Clicking Sounds: or Snapping

floor, walls and metal cabinets can make the sounds seem louder. The followlng chart describes the kinds of sounds that might be new to you, and what may be making them.

l

Probable Causes: Your refrigerator has two fans; you may hear the fan motors and moving The defrost timer makes a definite click when the refrigerator It also makes a sound when the refrigerator starts.

air

l

stops running.

l

Water Sounds:

When the refrigerator stops running, you may hear gurgling in the tubing for a few minutes after it stops. You may also hear defrost water running Into the defrost water pan. If your refrigerator has an ice maker, you may hear a buzzing [from the water valve], trickling water and the clatter of Ice dumped into the bin Your refrtgerator has a high-efficiency compressor and motor. It will run longer than older designs. It may even seem to run most of the time.

l

Ice Maker Running

Sounds: Sounds:

l

5