ELECTROLUX EFP6500X/A
Manual de Usuario

INSTALLATION
Drilling the Support surface and Fitting the Hood
SCREW FITTING � The hood support surface must be 135 mm above the bottom surface of the wall units. � Drill the support with a ø 4,5 mm drill bit, using the drilling template provided. � Cut a hole ø 125 mm in size on the support surface, using the drilling template provided. � Fix using the 4 screws 12a (4,2 x 44,4) provided.
12a

125
135
264 15 502 - 8 02 Vf

SNAP-ON FITTING � The hood can be installed either directly on the bottom surface of the wall units (min. 650 mm above the hob) using snap-on side supports. � Cut a fitted opening in the bottom surface of the wall unit, as shown. � Insert the hood until the side supports snap into place. � Lock in position by tightening the screws Vf from underneath the hood.

CLOSING ELEMENT � The space between the edge of the hood and the rear wall can be closed by applying the element 20 provided, using the screws supplied for this purpose.

20

EN

5