|
|
|
Usuarios conectados
Actualmente hay 5757 visitantes y
1 usuarios online. |
|
Productos
|
|
Información
|
|
Destacado
|
|
|
 |
|
|
No hay comentarios de productos.
Wiring of the circuit power supply (2/2) Lock the CNPOW, TSW, and FG3 by passing them through hole indicated in the through the power supply case fastener. diagram below. Make sure to pass the CNSH2 Wiring of the circuit power supply board (1)Style the CNPOW, TSW, and FG3. (2)Attach the CNSH2 [CAUTION] (3)Attach the power supply sheet. Make sure to attach the power (4)Style the CNPWR.
Fastener CNSH2.
TSW supply sheet after attaching the
CNPOW FB5 Power supply case
CN102 Power supply sheet Pass the CNPWR through FG1 sheet, and pull the wire out.
FG3
hole in the power supply CN103 Circuit CN101
FB2
F
C104
When pulling out the CNPWR and supply FB2, make sure that they do not pass over the C104 (electrolytic capacitor), CNSH2 E2 as this will cover the anti-explosion valve on top of the capacitor.
Fasten the CNSH2 and E2 with
power
1 B
ED-X8255(CC9XMN)
34
ZTP2 View from CNPWR
Clamp power supply case.
[CAUTION] As upper case touches the gray areas of diagram on the right, make
C104 tape, ZTP1 and ZTP2, after pass-
above C104 ing them through clamps of the
View from sure no wires protrude into these areas. Power supply the side
Power supply sheet Louver of
C104
C104 the power
supply case Correct
case holes
Incorrect
Don�t wire E2 on the louvers. Fasten E2 with ZTP1. Make sure to stick the tape The solid line in diagram indicates an example correct wiring. along outline of the power supply case holes as shown ZTP1 The dotted lines in the diagram indicate examples of incorrect wiring. in the diagram.
Outline of (solid line) power supply Correct Incorrect
(dotted line)
Wiring diagram 2
|
|
|
> |
|
