HUSQVARNA EA850
Manual de Usuario

SAFETY INSTRUCTIONS
Machine�s safety equipment
This section describes the machine�s safety equipment, its purpose, and how checks and maintenance should be carried out to ensure that it operates correctly. See the �What is what?� section to locate where this equipment is positioned on your machine. The life span of the machine can be reduced and the risk of accidents can increase if machine maintenance is not carried out correctly and if service and/or repairs are not carried out professionally. If you need further information please contact your nearest service workshop. WARNING! Never use a machine with faulty safety equipment. The machine�s safety equipment must be checked and maintained as described in this section. If your machine fails any of these checks contact your service agent to get it repaired. WARNING! Always stop the engine before you work on any part of the cutting equipment. This continues to move even after the throttle is released. Check that the cutting equipment has stopped completely and remove the HT lead from the spark plug before you start any work on it.

Cutting equipment

The cutter is designed and manufactured to withstand the loads that edging of a lawn involves. Check the cutting attachment for damage or cracks. A damaged cutting attachment should always be replaced.

!

Locking nut

!

The locking nut secures the cutting attachment on the output shaft. Protect your hand from injury when assembling, use the blade guard as protection when tightening with a socket spanner.

Cutting attachment guard
When �tting, tighten the nut in the opposite direction to the direction of rotation of the cutting attachment. To remove it, undo the nut in the same direction as the cutting attachment rotates. (CAUTION! The nut has a left-hand thread.)

This guard is intended to prevent loose objects from being thrown towards the operator. The guard also protects the operator from accidental contact with the cutting attachment.

CAUTION! The nylon lining inside the locking nut must not be so worn that you can turn it by hand. The lining should offer a resistance of at least 1.5 Nm. The nut should be replaced after it has been put on approx. 10 times.

General safety precautions
� Check that the guard is undamaged and not cracked. Replace the guard if it has been exposed to impact or is cracked. Only use cutting attachments with the guards we recommend! See the chapter on Technical data.

�

! !

WARNING! The machine can cause serious personal injury. Read the safety instructions carefully. Learn how to use the machine.

WARNING! A faulty cutting attachment may increase the risk of accidents.

CAUTION! Please read the operator�s manual carefully and make sure you understand the instructions before using the machine.

4 � English