SHARP DXV88W
Manual de Servicio

DX-V88W
� Press the ON/STAND-BY button. Is 7 seg LED displayed ? Yes Is the SHARP logo screen displayed ? No Yes "The SHARP logo is not displayed." "7 seg LED is not displayed."

No

Is "ERROR" displayed ? No Can the tray be open or closed, and can the disc be changed ? Yes Is No Disc displayed ? No Can a Video CD be played ? Yes Can the Audio signal be heard ?

Yes

"ERROR is displayed."

No

"The changer mechanism is malfunctioning."

"No Disc is displayed." Yes

No

"The Video CD cannot be played normally."

"No sound is heard." No

Yes Is an audio signal being output from the microphone ? No Yes The microphone signal is not being output.

End

� The SHARP logo is not displayed.

Is the voltage on pin 52 (VREF) on IC14 (IS3209) about 1.3 V ? Yes Is a 13.5 MHz clock signal available at pin 79 (PCLK) on IC14 ?

No

Check D103, C150 and R128.

Check the soldering on IC14 and the voltage at each pin. No

Yes Is the signal shown in waveform drawing 8, 9 and 10 being supplied to pin 82 (HSYNC), pin 84 (VSYNC) and pin 86 (YUV7) on IC14 ? Yes Is a video signal available at pin 64 (VDAC) on IC14 ? Yes Check the terminal PWB connector and each transistor. No Check the soldering at pin 64 on IC14, and at R126 and R178. If there is no problem, IC14 is defective. Check the soldering on IC15 (ES3210) and IC16 (4M DRAM) and the voltage at each pin.

No

� 31 �