JVC DX-T9J
Manual de Usuario

@ Speakers
To connect the speaker cords

Speaker layout To enjoy multi-channel sound, locate the speakers as follows. If you cannot locate like this, adjust the speaker setting by using the SPK. SETTING menu (see page 38).

� When connecting the speaker cords, match their polarity with that of the speaker terminals: blue/red/green/white/ gray to (+) and black to (�).
From right front speaker (blue/black) From left front speaker (blue/black)

To remove the speaker grilles of the front speakers
Holes From right subwoofer (red/black) From left subwoofer (red/black) From center speaker (white/black) speaker (green/black) From left surround speaker (white/black) From right surround Projection

Speaker grille

� Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the System. � The front and center speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers. � When placing the speakers near a TV set, turn off the TV�s main power switch or unplug it before installing the speakers. Then wait at least 30 minutes before turning on the TV�s main power switch again. Some TVs may still be affected even though you have followed the above instruction. If this happens, move the speakers away from the TV. � DO NOT connect more than one speaker to each terminal. � DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

Preparing the remote control
When using the remote control, point the top of the remote control toward the remote sensor as directly as possible. If you operate it from a diagonal position, the operating range (approx. 5 m) may be shorter.

R6(SUM-3)/AA(15F)

� Dispose of batteries in the proper manner, according to federal, state, and local regulations.

DO NOT recharge, short, disassemble, heat the battery or dispose of it in a fire.

5