WHIRLPOOL DWU7500BAX
Manual de Usuario

Maintaining

the Dishwasher

To Change

Panels:

The interior is normally self-cleaning. Occasionally" check the bottom of the dishwasher tub and clean out pieces of food which may collect there. Periodically clean the bottom edge of the dishwasher door liner. Food and liquids drip onto this area when the dishwasher is loaded, If yon notice an odor in your dishwasher, it may be due to a strong "ehemical" or chlorine odor from the dishwasher detergent. Using a different detergent, especially a lemon scented one, will probahly eliminate the odor, In some instances the smell of the rinse additive may be strong, Purchase a fresh package and see if it is better, Lastly, if the dishwasher is rnn only every eouple of days, an odor may develop. Use the Rinse & Hold feature daily to remove any food soil that may cause an odor. To remove an odor, try"one of the following: 1. Place baking soda in both sides of the detergent dispenser. Select Light/China and let the water eirculate for about 10 minutes, Stop the dishwasher by unlatching the door and let stand overnight. Then, restart the dishwasher by latching the door and let it complete the cycle. 2. Select the Light/China cycle and let the dishwasher fill with water. Then open the door and pour one cup of chlorine bleach into the bottom of the dishwasher. Latch the door and let the dishwasher complete the cycle, Clean the control panel and front panel with a soft damp cloth and liquid spray cleaner. Do not use any abrasive powders or cleaning pads.

A. Remove three screws holding the metal trim strip on one side of the door. Take note of how the trim comes off. B. Grasping the lower part of the door panels, bow panels out carefnlly at the bottom while sliding panels far enough to clear the flange on the trim strip which was not removed and remove panels. C. Arrange panels so the desired color is facing out. D. Plaee door panels (notched side up) behind the metal trim at the bottom of the door. Bow the panels so they fit behind the control panel at the top. E. Slide the panels under the side metal trim which was not removed. To do this, it will be necessary to compress the backing behind the colored panels. F. Reinstall the metal trim whieh was removed earlier. To do this, start by inserting the tip end of the trim strip behind the control panel. Align the holes and replace the three screws. G. The lower acoess panel is held by four screws (two above the panel and two below). With these removed, the panel may be removed to make it easy to change panel colors. H. with the lower access panel removed, remove the four screws along the bottom of panel and loosen the trim which holds the panels. Once the desired panel is facing out, replace the trim, and reinstall the panel to the dishwasher. Use care when changing panels to be certain you

Changing

Panels

Your Maytag dishwasher comes with reversible panel inserts which are pre-assembled at the factory-.This enables you to select the color you want before your dishwasher is installed or choose another color at a later date.

are not injured on sharp edges and that the panels are not damaged. If you have any questions concerning changing panels, contact your local Maytag Dealer.

PAGE 13