Operating sequence
1. Check the filters
Ensure they are clean and properly positioned (see cleaning instructions).
8. Start the programme
Depress the On/Off pushbutton. The On/Off indicator light comes on and the machine will start.
2. Check that there is rinse aid and salt 3. Load the dishes
Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it. Slide the basket back into the machine.
9. At the end of the washing programme
At the end of the washing programme the dishwasher stops automatically. The On/Off indicator light remains on until the On/Off pushbutton is depressed.
10. Switch off the dishwasher
Switch off the dishwasher by pressing the On/Off pushbutton. When the wash programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
4. Ensure that the spray arms can rotate freely. 5. Measure out detergent
Add the required amount of detergent into the dispenser according to the "Washing programmes" chart and close the lid.
6. Close the detergent dispenser lid 7. Select the programme
Close the door. Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker.
In general it is not advisable to open the door while the machine is working; especially during the hot phase of the washing programme; this could cause hot water to escape. However, the dishwasher has a safety device that ensures, if the door is opened that the machine stops immediately.
Care must be taken if the door is opened after a programme has finished, as steam may escape.
