Troubleshooting
WARNING Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock. If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to remedy a problem by following these hints, consult your dealer or Philips for help.
E n g l i s h
Problem
No power
Solution
� Check if the AC power cord is properly connected. � Press the STANDBY ON on the front of the DVD system to turn on the power. � Refer to your TV�s manual for correct Video In channel selection. Change the TV channel until you see the DVD screen. � Check if the TV is switched on. � If the progressive scan feature is activated but the connected TV does not support progressive signals or the cables are not connected accordingly, see page 15 for proper progressive scan set up or deactivate the progressive scan feature as below: 1) Turn off your TV progressive scan mode or turn on to interlaced mode. 2) Press and hold EJECT on the DVD Player. 3) When the disc is ejected, press and hold EJECT again, and numeric keypad �1� on the remote control at the same time for few seconds. � Sometimes a small amount of picture distortion may appear depending on the disc being played back. This is not a malfunction. � Connect DVD Player directly to the TV. � Make sure the disc is compatible with the DVD/ Player. � Ensure that the DVD Player�s TV Type is set to match that of the Disc and your TV. � Adjust the volume. � Check that the speakers are connected correctly. � Check the digital connections. � Check if your receiver can decode MPEG-2 or DTS and if not, please make sure the digital output is set to PCM. � Check if the audio format of the selected audio language matches your receiver capabilities.
No picture
Distorted picture
Completely distorted picture or black/white picture with DVD
No sound or distorted sound No audio at digital output
Visit us at www.philips.com/support for service support 36
