Getting Started
Setting up Progressive Scan feature (for Progressive Scan TV only) The progressive scan display twice the number of frames per seconds than
7 Select {COMPONENT} to {YUV}, then
press OK to confirm.
8 Select {PROGRESSIVE} to {ON}, then OK
to confirm. � The instruction menu appears on the TV.
ACTIVATING PROGRESSIVE SCAN: 1. ENSURE YOUR TV HAS PROGRESSIVE SCAN. 2. CONNECT USING YPBPR (GBR) VIDEO CABLE. 3. IF THERE IS DISTORTED PICTURE, WAIT 15 SECONDS FOR AUTO RECOVERY.
OK Cancel
interlaced scanning (ordinary normal TV system). With nearly double the number of lines, progressive scan offers higher picture resolution and quality. IMPORTANT! Before enabling the progressive scan feature, you must ensure: 1) Your TV can accept progressive signals, a progressive scan TV is required. 2) You have connected the DVD player to your TV using Y Pb Pr (see page 10.)
9 Press 1 to highlight
OK
in the menu
1 Turn on your TV. 2 Turn off your TV progressive scan mode
or turn on interlaced mode (refer to your TV user manual.)
and press OK to confirm. There will be a distorted picture on your TV at this state until you turn on the progressive scan mode on your TV.
3 Press POWER on the remote control to
turn on the DVD player.
0 Turn on your TV progressive scan mode
(refer to your TV user manual.) � The below menu appears on the TV.
CONFIRM AGAIN TO USE PROGRESSIVE SCAN. IF THE PICTURE IS GOOD, PRESS OK BUTTON ON REMOTE.
4 Select the correct Video Input channel.
(See page 15). � The DVD background screen appears on the TV.
5 Press SYSTEM MENU. 6 Press 2 repeatedly to select {VIDEO
SETUP PAGE}.
OK
Cancel
! Press 1 to highlight
General Audio Video Preference - - Video Setup Page - TY Type TV Display Progressive Sharpness Brightness Contrast Component On Off
OK
in the menu
and press OK to confirm. � The set up is complete now and you can start enjoy the high quality picture.
TIPS:
To return to the previous menu, press 1. To remove the menu, press SYSTEM MENU.
