WHIRLPOOL DU8016XX4
Manual de Usuario

UsingRinse AgentDispenser
Rinse agent dispenser Keep the rinse agent dispenser filled with a liquid rinse agent such as Jet-Dry.� A rinse agent greatly improves the drying of dishes by helping water flow off of them during the last rinse. A rinse agent also keeps water from forming droplets and dryrng as spots. A small amount of rinse agent is automatically released into the rinse water during the final rinse of each cycle. For best drying results, check the dispenser periodically to see if it needs refilling. To check dispenser The center of the Fill Indicator Cap will be clear when dispenser needs refilling. An �E� will also be visible Inside the dispenser when the cap is removed and the dispenser is empty. On some models: 1. Press the flexible clear top of the Fill Indicator Cap to draw rinse agent into cap. NOTE: You may need to press cap two or three times to remove all of the air bubbles from the cap. 2. When rinse agent does not show in cap, even after pressing flexible cap several times, dispenser needs refilling.

Press flexible clear top, on some models

Keep rinse agent dispenser filled for best drying results

To fill dispenser The dispenser will hold 6 ounces of rinse agent. Under normal conditions, this will last about 3 months. You do not have to wait until the dispenser IS empty to refill It, but do not overfill it. Make sure the dishwasher door is fully open before removing the Fill Indicator Cap. Do not fill past the smallest opening in the lower pat-t of the dispenser. If you overfill, excess rinse agent can come out. This will not harm the dishwasher, but could cause over-sudsing. Clean up any spilled rinse agent with a damp cloth. Replace the Fill Indicator Cap and keep it tightly closed. NOTE: Because your dishwasher is designed to use a liquid rinse agent, you do not need to use a solid or bar-type rinse agent.

R RegIstered 10

Trademark

of Bencklser

Consumer

Products.

Inc