WHIRLPOOL DU5216XW0
Manual de Usuario

Common Dishwashing Continued

Problems

Dishes not washing clean Water is not hot enough Water temperature should be at least 140,-F (60-C). Set water heater thermostat to a higher settrng. Run water at sink untrl hot before starting. Improper loading Make sure dashes and glassware are loaded so spray reaches all surfaces and items drain properly. Do not overload. Do not nest items. Make sure large Items do not block spray from reaching detergent dispensers. Spray arm not rotating freely Check spray arm to make sure It turns freely after loading. Be sure a utensil IS not sticking out the bottom of the silverware basket and blockrng the spray arm from turning. Not enough detergent or improper detergent Use more dishwasher detergent. Use detergent with highest available phosphorus content.. especially with hard water. �Old� detergent Use only fresh dishwasher detergent. Store tightly closed container in cool, dry place Discard old detergent. Do not fill drspensers until ready to start dishwasher. Water pressure may be low, dishwasher not filling properly is

2. Start dishwasher and unlatch door to stop it when it has filled for the wash part of the cycle. 3. Add I/a to % cup (120 to 240 mL) of citric acid crystals (usually available in drugstores). 4. Close and latch door to complete cycle Permanent solution: Install an iron or manganese filter or water softener to home water supply. gust spots on stainless steel-OR - Dark spots on flatware: stainless steel, silver plate, or sterling Allowing salty or acidic foods such as mayonnaise, vinegar, fruit juices, salad dressings, milk products to remain on flatware Rinse flatware that is to stand for several hours before washing (use the Rinse & Hold Cycle). Clean stained items with silver polish and re-wash Do not put stainless steel and silver flatware in the same silverware basket compartment. Direct contact between these metals can cause permanent damage to the silver. Undissolved detergent coming in contact with flatware Remove spots with silver polish. Avoid spilling concentrated detergent on wet flatware.

If water pressure is low, do not use water for other purposes while dishwasher is runnrng (to assure correct fills).

Bronze tarnish on silverplate Silverplate is worn off. Exposed base metal takes on a bronzed hue Remove tarnish with silver polish. Have silver replated. Water left in bottom of dishwasher above grate Dishwasher cycle not completed Allow dishwasher to complete cycle. Some remaIrIng water IS normal and keeps seals from drying. Clogged drain air gap Some plumbing codes require use of a drain air gap between an undercounter dishwasher and the drain system of the house. The air gap is usually located above the sink or on the top of the counter near the dishwasher to prevent the possibility of water backing up from the drain into the dishwasher due to a plugged drain. The drain air gap is not a part of the dishwasher and is not covered by the dishwasher warranty. The drain air gap should be kept clean to ensure proper draining of the dishwasher.

Cloudy film on glassware, etching permanent corrosion Too much detergent in soft water Check for rainbow hue on glasses. A rainbow hue is the first sign of etching (corrosion of glass). Reduce the amount of dishwasher detergent. Use a detergent with a lower phosphorus content Inadequate rinsing If water pressure IS low do not use water for other purposes while dishwasher is running (to assure correct water fills). Make sure dishes and glassware are loaded properly to assure adequate rinsing and drarnlng. Do not overload. Dishes & interior of dishwasher yellow or brown Iron or manganese in water Temporary remedy: 1. Set empty dishwasher for a �one wash� cycle.