FUNCTION An output terminal for the continuous chroma sub-carrier frequency wave, with an amplitude of 0.7Vp-p (typ). Also the dc level shows chroma killer status, with a level of 3.5V for B/W and 1.5V for Color.
INTERFACE
14
RGB VCC(9V)
15
YS/YM SW /Spot killer
A Vcc terminal for RGB block, PIF det. Output and sound output circuit. Supply 9V. A terminal for switching of EXT RGB Mode and fast Half tone.
-
16 17 18
EXT.R IN EXT.G IN EXT.B IN
Input terminals for EXT RGB signals. The signals are clamped by capacitors, therefore the input impedance should be low, 100 ohms or less is recommended. For this input, the brightness and RGB contrast is adjustable, the ABL/ACL limits the output level. This ABL/ACL may be turned On and OFF. OFF : for small area like OSD ON : for large area like TELETEXT (input level 0.7Vp-p/100IRE) The GND terminal for Y/C circuit. Terminals for R/G/B signal output. Connect resistances to GND, for the current source if the slew rate is not enough. Due to the source current limitation, the resistances should be 2.0 or more.
