SONY DSR-1600
Manual de Servicio

3-11. Upgrading the FPGA Program Version

3-11. Upgrading the FPGA Program Version
The DSR-1800/P/1600/P mounts the FPGA (field programmable gate alley) on the process board and uses flash ROMs for loading this program. The version of these flash ROMs mounted on the board can be upgraded using the following method.

3-11-1. Upgrading the Version
(1) Prepare a DJ-499 (J-6444-990-A). (2) Write the required number of rewrittable program files in the PROM (M27C1001-70F1 (F8) (8-75958-91) or equivalent). Refer to the following for the number required. (3) Mount the PROMs in order from the one with the smallest number to the DJ-499 IC100 to IC103. (4) Set the DJ-499 as follows. (5) With the power of the unit set to OFF, mount the connector of the corresponding board to DJ-499. (6) Turn ON the power of the unit. . Of the three LEDs on the DJ-499, the green D1 at the end lights up and goes off. (The dummy data will be loaded in the FPGA. It will be completed when D1 goes off.) . The same green D1 will blink after a while. (The flash ROM on the board is erased and new data is downloaded.) . It stops blinking, and the green D2 in the middle lights up, meaning that upgrading has ended normally. . If the red D3 in the middle lights up halfway through, it means that a writing error has occurred. Check if the DJ-499 is connected properly, and perform from step (6).
COPY LOAD MD 0 MD 1

3-11-2. Setting of DJ-499
Model name DSR-1800/P Board name DPR-175 Connect to DJ-499 CN454 CN455 DSR-1600/P SSP-23 CN1454 CN1455 PROM file name SIF-00/01/02 FU-00/01/02/03 SIF-00/01/02 FU-00/01/02/03
2000 OTHER

Switch setting of DJ-499 S3

3-36

DSR-1800/P/1600/P