PIONEER DRM-UF701/ZUCYV/WL
Manual de Servicio

DRM-UF701

7. GENERAL INFORMATION
7.1 INSTALLATION

�

� Always be sure never to touch the contacts or ports when operating units.

INSTALLATION-RELATED PRECAUTION
Before installing the unit, read and follow the-following instructions. � This unit can be installed on only one 700-disc changer DRM-7000. � This unit occupies two of the rear bays. The rear bays where this unit can be installed are the odd-numbered rear bays (Nos. 1, 2, 3, 7, 9, 11, 13, 15 and so on). � It is impossible to install another unit in 1 or more of this unit's rear bays (odd numbered). � It is reversed although a changer buzzer sounds in DVD-ROM drive when a changer interface cable is connected. It does not sound in a disc flip unit.

7.2 DISASSEMBLY
Remove the RV Top Cover
The RV Top Cover is fixed with Claws at the front and with screws at the rear. To remove the RL Top Cover, proceed as follows. Failure to do so may damage the claws. Note: In the remove of RV top cover, or other work Be careful not to damage RV Gear (A). RV Top Cover

4

2

Claw RV Top Cover

3
While pressing the PL lock lever toward RELEASE, slide the RV Top Cover backward. (It will stop after sliding approx. 1 cm backward.) Claws (both sides)

Press and bend the front part of the PL Upper Cover from the left and right sides to unhook the claws, then lift up the cover. (Do NOT try to lift up the cover forcibly with the claws unhooked. This may damage the claws and make it impossible to reattach the cover.)

1

�4

� When reattaching the cover, reverse the above procedures. (Place the cover approx. 1 cm backward and hook the claws, then slide the cover forward.) � Observe the driver unit from the rear to check that the claws are firmly engaged.

9