WHIRLPOOL DP8700XBN1
Manual de Usuario

A �en shows what steps are in each cycle Cycle Light Wash A single wash for pre-rinsed or lightly soiled loads. NOTE: The Cycle Control knob does not move while the dishwasher heats water to 135°F (57°C) in the final rinse (marked +). If the Hi-Temp Wash option is selected water will also be heated in the main wash (marked n). See page 10. Rinse & Hold q For rinsing a few items to be washed one or sib more days later. Do not use detergent. Drying with heat may cause food to bake on dishes. .I-+ .
lt

Wash Rinse

Main Wash

Rinse Rinse

Dry

Cycle Time (Minutes)

.

60�

.

.

16

*Cycle time includes heated dry time. Cycle time may vary depending on the temperature the water entering the dishwasher.

of

What
Hi-Temp

happens
Wash option

in each

option
SELECT

If the Hi-Temp Wash option is selected, water is heated in the dishwasher during the main wash of the Heavy Wash, Normal Wash and Light Wash cycles to improve washability. The Hi-Temp Wash option is automatically selected for the Pots 8 Pans cycle. See �Cycle selection chart� on pages 9 and 10. NOTE: The DELAY/WATER HEATING signal light will glow while the water is heating. The Cycle Control knob does not move while the water is heating. . The Cycle Control knob will begin moving again when the water temperature reaches 135°F (57°C). The heating time is based on the temperature of the water supply as it enters the
l

l

l

l

dishwasher. The cooler the water, the longer the heating time. If water temperature at the faucet is below 120°F (49�C), have a qualified person raise the water heater�s thermostat setting. See page 14. The dishwasher does not pause to heat the water if the water entering the dishwasher is already 135°F (57°C).

10