SERVICE MODE
The following confirmation can be performed when the Service Mode is set. 1. How to set the Service Mode. To set the Service Mode, the following method is available. 1) Confirm the set is not powered on. 2) Confirm the following settings. OPEN/CLOSE detect switch (S812) ........ OFF Solder Land (SL812) ................................ OPEN [HOLD] switch (S802) ............................... OFF 3) Short the solder land SL805 (TEST) on the MAIN board. 4) Turn on the main power.
2. Operation when the Service Mode is set. When the Service Mode becomes active, following messages are displayed onthe remote control LCD.
Microcomputer version display
VP073
:
1) Turn off the power. 2) Open the solder land SL805 (TEST) on the MAIN board. Note : The solder should be removed clean.
