SONY DMS-EX210S
Manual de Servicio

3-23. Replacing the X-axis Linear-way

Installation Procedure Linear-way at the side of the basic console 1. Attach the parts by reversing steps 16 through 18 of the removal procedure. 2. While putting the X rail (upper) assembly to the two X reference pins, fix them with the four hexagonal head cap bolts (with dropsafe). m . The distance from the right end of the frame to the X joint must be 5 ± 0.5 mm when viewed from the side of the rear door. . It must not be possible to insert a thickness gauge (t = 0.05) between the linear-way and the X reference pins. 3. Fix the X joint with the four hexagonal head cap bolts by reversing step 14 of the removal procedure. Linear-way at the side of the extension console 4. Temporarily fasten a new linear-way by reversing steps 22 through 25 of the removal procedure. n Do not completely fasten the screws used to temporarily fix the linear-way leave them loose. 5. Slide the X-axis linear-way at the side of the extension console. While putting it to the Xaxis linear-way at the side of the basic console, temporarily fasten the two hexagonal head cap bolts of (c) and (e) removed in steps 20 and 21 of the removal procedure. n Attach the X-axis linear-way to the X joints with the two hexagonal head cap bolts of (c) and (e) so that no clearance is made by the spring washers between the linear-way and X joints.
X joint (c) M4 x 14

Right end of the frame 5 ±0.5 mm

X joint

X-axis linear-way

Side of the rear door X reference pins The clearance must be 0.05 mm or less. Reference pin

X-axis linear-way

Side of the basic console

X joint Side of extension console (e) M4 x 14 Put the linear-way at the side of the extension console to here.

X-axis linear-ways

DMS-B150L/B210S/B80L/B110S/EX150L/EX210S

3-83