PANASONIC DMRE55EB
Manual de Servicio

4.1. About lead free solder (PbF)
Distinction of PbF P.C.B.: P.C.B.s (manufactured) using lead free solder will have a PbF stamp on the P.C.B.

Caution:

- Pb free solder has a higher melting point than standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher. Please use a high temperature soldering iron. In case of the soldering iron with temperature control,please set it to 700 ± 20°F (370 ± 10°C). - Pb free solder will tend to splash when heated too high (about 1100°F/600°C). - When soldering or unsoldering, please completely remove all of the solder on the pins or solder area, and be sure to heat the soldering points with the Pb free solder until it melts enough.

5. Each Buttons 6. Taking out the Disc from RAM-Drive Unit when the Disc cannot be ejected by OPEN/CLOSE button
6.1. Forcible Disc Eject
6.1.1. When the power can be turned off.

1. Turn off the power and press [STOP] [CH UP] keys on the front panel simultaneously for 5 seconds.
6.1.2. When the power can not be turned off.

1. Press [POWER] key on the front panel for over 10 seconds to turn off the power forcibly, and press [STOP] [CH UP] keys on the front panel simultaneously for 5 seconds. 6.2. When the Forcible Disc Eject can not be done. 1. Turn off the power and pull out AC cord. 2. Remove the Top Case. 3. Remove the Front Panel. 4. Remove 4 screws and Upper Base Unit from DVD-RAM Drive. 5. Take out the disc and put the Opener Roller on fully position for

6